I hate cleaing my shower



....................



 


Aqua Mix Cleaning Products:


For ordering information, click here.

 

 

.........$129.95

 

AQUA MIX HIGH GLOSS SEALER is a specially formulated water-based blend of acrylic polymers that provides both a stain resistant surface seal and a durable high-sheen finish eliminating the need for two products. May also be used as a pre-grouting sealer. Is not affected by ultra-violet light.

Uses

Use on textured natural stone (such as tumbled marble, flamed granite, slate, sandstone, and quartzite), textured ceramic (rough to the touch), textured porcelain (rough to the touch), quarry, saltillo, terra cotta, cement pavers, masonry surfaces and other textured stone, and tile where a high shine is desired. Effective for interior applications only.

Recommended Surfaces

  • Adoquin/Cantera
  • Brick
  • Concrete Tile
  • Granite
  • Marble
  • Porcelain Tile
  • Quarry Tile
  • Quartzite
  • Saltillo Tile
  • Sandstone
  • Slate
  • Terra Cotta Tile

Coverage
Approximately 300 to 1,000 sq. ft. (30 m² to 95 m²) per coat per gallon (3.785 L), depending on type, porosity and texture of surface, temperature, humidity, and method of application.

Material Safety Data Sheet
Technical Bulletin

Method of Application

READ ENTIRE LABEL BEFORE USING

  • 1.) Read entire label before using.

  • 2.) For new installations sealer can be applied as soon as 48 hours after grouting.

  • 3.) Surface must be clean, dry, and free of existing sealers and coatings.

  • 4.) Apply using a sponge or paint pad applicator. Avoid puddling.

  • 5.) If 2 or more coats are applied, allow a minimum of 30 minutes drying time between coats (most surfaces will require more than one coat).

  • 6.) 2 hours after final coat conduct a test to determine if surface is completely sealed by applying water droplets to the surface. If water is absorbed, apply an additional coat. Wait 2 hours and repeat the test.

  • 7.) Ready for surface traffic 6 hours after final coat. Keep area dry for at least 6 hours. Achieves a full cure in 24 hours.

  • 8.) Clean applicator tools with water after each use.

 

 

 

Give us a call today !